Skip to main content

The Apple iPhone 5s was announced on September 10, 2013. Repair of this device is similar to the previous models, and requires screwdrivers and prying tools. Available as GSM or CDMA / 16, 32, or 64 GB / Silver, Gold, and Space Gray.

4098 Questions View all

iPhone 5s battery replace issues

Hello i replaced my iphone 5s battery but when start my phone battery charge status 1% when i recharge battery its jump and stuck on 27% percent

After i shutdown my phone and on it Again battery comes on 1% again are there any solutions

Also my phone randomly rebooting after 2-3 minutes

Answer this question I have this problem too

Is this a good question?

Score 0

Comments:

where did you get the battery from?

by

Add a comment

2 Answers

Most Helpful Answer

So you make Battery BSI track open. See around the battery connector you can see some parts are missing. If the coil is missing simply jumper it and enjoy.

Was this answer helpful?

Score 1

Comments:

Please explain more i not understand what you are mean

by

Add a comment

The symptoms your iPhone have is most likely caused by a damage logic board. Take a good look at the logic board around where the battery connector is, it is possible that you have knock of a small component of the logic board when you have replaced the battery. You might need a magnifier or microscope to see it, at the place where component is missing you can make a jumper between the two pads. Sorry for my poor English but I hope you understand what I try to explaine.

see this for example: https://youtu.be/Q4fIp9vgsB8

Was this answer helpful?

Score 0

Comments:

Hey

Unfortunately i not have  microscope but if there's any missing  part around  battery  socket are that component repairable?

And are you think maybe  the new  battery  have a problem  i am so scared  about component if they  missing

Sorry  for  my poor  English

by

I think the problem is in a missing component around the battery connector, take a magnifier and take a look, it isn’t that difficult to make a jumper, I use silver conductive glue to make this jumper. Much easier then with micro solderen.

by

Add a comment

Add your answer

Abdurrahman Najdi will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 29