Trying to read pcb
is this tolerance or what?
Is this a good question?
This particular guy is a weird one. There’s actually not a resistor in that position, it’s a filter. On the other hand—this filter doesn’t go bad. What makes you looking at battery_swi line?
Was this answer helpful?
I don’t think he has a problem with any device. He is trying to understand what symbols and abbreviations mean on schematic diagrams.
U r right ????@imicrosoldering
Yes this is the tolerance of the resistor. They usually have a tolerance of 1, 2, 5, 10 and 20 percent. These values are to indicate how much the component can vary from it’s from its nominal value.
Was this answer helpful?
@seif_mohamed I will post this on your previous question about MF
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 94