Rep: 119
4
2
Hi!
Is there any board view for Apple watch series 1 - 6 out there? It’s missing from ZXW .. A need it because I want to repair a 38 mm Apple Watch Series 3 which has 1 component came off from the motherboard and I want to know what it is…
Is this a good question?
Rep: 4.8k
11
5
1
hello Peter,
unfortunately, I don't think anybody has schematics for apple watches. I don't think they exist in the zone, and neither do the new iPad models. In such cases, we use experience and knowledge in the field of electronics. You need a good meter and some general knowledge in measuring passive consumer electronics. Unfortunately, to measure something and be sure that the measurement is correct - the element must be desoldered. Good luck :-)
It’s popular last times with the YouTube generation to buy "donors" - blocked ones and transfer parts without knowing what is that - I wrote about it above. This is a solution, but as you can see - it's quite short-sighted.
desolder, measure and email me, I’ll tell you some.
Was this answer helpful?
Thank you for answering! Thats what I thought :) The thing is the bord has very tiny water damage and the bad is corroded... This is a project I put on the side for now.... :D
I do I can fix it
Rep: 1
1
Past 24 Hours: 0
Past 7 Days: 3
Past 30 Days: 26
All Time: 485
1 Comment
I can fix it what type of damage?
by Panda _yt