Fix Your Stuff Community Store

Repair information and guides for the Apple iPhone 5s that was announced on September 10, 2013. Model: A1533, A1453, A1457, A1528, A1530, A1518

3531 Questions View all

Options

Display and touch is not working after connecting Front Cam FPC.

I have a iphone 5s whose display and touch is working perfectly fine without the Front cam FPC.However,when I connect my front cam FPC, there are lines on display and touch is also not working.I have already tried with 3 working displays.same issue with all.

All diode mode reading of my frontcam FPC connector is matching with a working board.

I know there are CUMULUS_TO_PROX_TX_EN_BUFF,CUMULUS_TO_PROX_RX_EN_1V8 & 45_PROX_TO_CUMULUS_RX data lines are connected with Cumulus and sage.I am not mentioning powerline rail,if there has been any fault it would have been detected by diode mode. I have only tried with cold method i.e without powering the phone. Can any one help me to troubleshoot my problem?

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest

Options

Hello Repairman

Just an idea, but I had similar problems finding the touch connector damaged (vertical on the left side). It could be that it created a bad connection, but I don't understand why it affects another connector.

It is a very weak connector and easy to damage / deform.

Good luck!

Was this answer helpful?

Yes No
Score 0
Add a comment

Add your answer

THE REPAIRMAN will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 61