Rep: 13
1
1
Washer does not seem to go into "high" spin cycle and leaves heavy item wet at end of cycle. Tried to extend spin cycle, and tried to re-run entire wash cycle with no improved results.
Is this a good question?
Rep: 685.2k
3.4k
1.1k
2.6k
This can be caused by any one of these:
When the clothes are wet at the end of a cycle, check these:
Motor coupler
Spin cycle
Siphoning
Water-inlet valve
Let us know if it starts happening again for more detail.
Was this answer helpful?
The washer was working fine then a pop and rubber burning smell. Now it has the same symptom as above
and I only have a towel in the washer and it does not get to a high speed spin. It toggles back and forth to a relative slow spin for a little stops and then changes directions and keeps doing that and then finishes as if all went ok
Thanks Stan B
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 2,698
2 Comments
The first thing I would try is to use a smaller, lighter load. The load may be so heavy it can't get up to speed.
by rj713
I ran the small bathroom rug back through wash cycle with other items & it finally spun correctly. Thanks!
by Ybsul