Skip to main content

Repair guides and support for riding, or ride-on, mowers, also known as lawn tractors, of all types used in tending large tracts of land.

847 Questions View all

I have a general wiring question about ignition wire harness?

I am actually working on a dixon ztr 308 zero turn mower and am wondering if I have to use a wire harness to connect keyed ignition switch or if I can wire strait from ignition to solenoid, magneto, and ground? Is the harness just for a quick disconnect?

Answered! View the answer I have this problem too

Is this a good question?

Score 0
1 Comment

Thank you for the confirmation all the wires were corroded and direct wired now with better quality wire. Runs great now

by

Add a comment

1 Answer

Chosen Solution

A harness is for consistent easy assembly at the factory. You can direct wire with a connector or not. The ZTR 429 I’m rebuilding wouldn’t engage the blade clutch, the connector was so badly corroded. I bypassed it using wire nuts. Now waiting on new drive cones to finish the rebuild.

Was this answer helpful?

Score 1
Add a comment

Add your answer

Wesley Neal will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 51