3.0 diesel to SBC engine swap

  • I'm probably going to get some grief over this, but I'm swapping the 3.0 diesel in an 81 300D for a 350. I'd like to have a clean engine bay (no exposed wires and such). I'm down to 3 pieces that I'm unsure of. 1: the resistor pack on the passenger firewall 2: a small electrical box at the uppermost drivers wheel well and 3: a smaller electrical box on the drivers wheel well just below the cruise control canister. Do these control body electrical or engine electrical?

Update (01/20/2019)

Block Image

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment