Fix Your Stuff Community Store

Repair information and guides for the iPhone 6 Plus that was released on September 19, 2014. Model: A1522, A1524

1525 Questions View all

Options

iPhone 6 plus no signal after touch ic repair

Hello,

I have a iphone 6 plus that had a touch ic disease so replaced the chip and made the M1 jumper. The phone works fine now except it has no cellular reception but wifi works great though. Any ideas on where to look for the problem? It worked fine prior to the repair.

Answered! View the answer I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Chosen Solution

Options

Check the antenna interconnect wire on the back of the board and insure that the board was properly mounted in the housing. If all of that is okay, then you may have applied too much heat to the board and caused issues in the RF section, which is the bottom, front and back, of the logic board. Look for solder bridges, measure the BBPMU voltages etc.

Was this answer helpful?

Yes No
Score 1
Add a comment

Add your answer

Hernando Berg will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 265