Hi,today i wanted to fix my front camera for my iphone 6 plus
After that i tried turning on the phone but it wouldnt turn on
I disconnected and reconnected the flex cable for battery but no changes
But when i connect only the left side of the connector it turns but randomly restarts
When i connect both properly it turns off instantly as show in the video below
Please help!
Is this a good question?
Rep: 221.4k
15
289
807
The left side of the connector is the positive battery terminal (from the videos perspective), that’s probably why the phone lights up. If it will not turn on when the battery is fully connected, it’s either a battery issue (unlikely in this case) or a logic board issue. You may have damaged something when you did the repair. One thing you could try is to disconnect the Front Camera flex and then reconnect the battery fully to see if it boots up properly. If it does, then the FCAM flex may be damaged. If it doesn’t, then try disconnecting the entire screen assembly and boot. You’ll need to connect it to an iTunes enabled computer to see if the phone is recognized.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 105
1 Comment
Your video is close to useless since you aren't showing your actions as you're doing them. Also, it's vertical for some reason.
Check and reseat all of the display and front flex cables and see if it still happens. If it does, disconnect your front flex cable (camera, etc) and try again.
by Steve