Rep: 35
2
so i tryed crazy glue did not help i tryed using a different screw an nope that what caused the stripped screw to start i looked at a video yesterday it said Ph1 but didnt work an no rubber bands at all i also tryed using a drill in reverse no good either im out of options
Is this a good question?
Rep: 41
1
If you have about 1/8 to 1/4 inch screw sticking out try a small vice grip if you do not have enough screw to do that there is a thing called an easy out or screw extractor. You should be able to get them at a hardware store and make sure to run the drill in reverse and to put lots of pressure on it.
Was this answer helpful?
Rep: 460
10
2
2
If they are not too deep, you could put a rubber band between the screw and the screwdriver to get more traction.
Was this answer helpful?
if u look close u can still a tiny bit of screw it is savable
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 46
