Touch wonky after screen replacement

Hello - I had to replace my battery because it was ballooning and the screen becauae it was bent. So I got all of that in, but touch is not working properly. Can someone point me to the ribbon that's s needed for touch? I feel like I may have not plugged it in all the way.

Thanks!

Ward

Answer this question I have this problem too

Is this a good question?

Score 1

1 Comment:

I purchased a new Surface Pro 5 screen and upon install, touch sensitivity and accuracy are greatly reduced from the previous original screen. I have attempted to run calibration procedures through the Windows interface with no luck on correcting the issue. I have also uninstalled and reinstalled the drivers through the control panel.

by

Add a comment