Fix Your Stuff Community Store

A collection of guides and support to help with washer repair.

3472 Questions View all

Options

Only drains after power rest and leaving lid open

GE Washer

GTW460ASJ0WW

When I start a normal cycle the washer runs normally until it gets to drain and spin part of the cycle. It makes a low 'hum' noise and eventually stops.

If I unplug the washer for about 30 seconds, plug it back in, leave the lid open the washer drains on its own after about an hour (I think, could be hours). So the pump seems to work but its refusing to work properly during normal operation.

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Most Helpful Answer

Options

Your conclusion that the drain pump works is not substantiated by your statement that it takes an hour to drain. Rather it shows that the pump is not working and the drain may be partially clogged. Here are the things you need to look at:

Cause 1

Drain Pump

Sometimes, small objects or articles of clothing can get caught in the drain pump. To determine if anything is blocking the drain pump, remove the drain pump and check the pump for obstructions. If the drain pump is clear of obstructions, but is still noisy during the drain cycle, replace the drain pump.

Cause 2

Clogged Pump or Hose

Sometimes, socks and other small articles of clothing can get into the drain system and clog the pump hose or the pump itself. Remove the hoses from the pump and check for any obstructions.

Cause 3

Lid Switch Assembly

The lid switch assembly prevents the washer from spinning when the lid is open. If the lid switch assembly fails, the washer will not drain. To determine if the lid switch assembly is defective, use a multimeter to test each of the lid switches for continuity. If a lid switch does not have continuity, replace it.

Was this answer helpful?

Yes No
Score 2

2 Comments:

When I lay the drain hose on the ground it flows quite freely. It doesn't only drain after being left for a while but also the first attempt at running a cycle afterwards. Any subsequent cycles however do not drain.

by

OK if is draining when disconnected look further down the line. You may need to snake drain pipe.

by

Add a comment

Add your answer

Nick Coffin will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 18

All Time: 1,318