Rep: 21
1
1
Hi I can’t seem to find the right answer I am trying to restore an old 6s but each time I do it’s like almost done it says “error -1 or 4013 . Or it says phone could not be found I tried 3 computers and different cords and different usb spots need any help
Is this a good question?
Rep: 159.7k
11
191
368
If I remember correctly the fix for this is to remove the baseband chip and make jumpers for certain pads. Then the chip would need to be reballed by a stencil and put back onto the logic board.
4013 can sometimes be the NAND needing reprogramming and/or replacement using ipbox or naviplus pro 300.
-1 is for baseband like I said above.
Both of these fixes require microsoldering.
Was this answer helpful?
Yes! I contacted eBay sellers and found it out
Past 24 Hours: 0
Past 7 Days: 1
Past 30 Days: 1
All Time: 1,175
