How to resolve elevated screen upon assembly replacement?
After repairing my iPod and replacing the LCD assembly I have noticed that parts (not the entire screen) are raised. I replaced the adhesive around the unit with generic 3M "tape" with the mindset that it would holster the screen down to a flushed position as before. However, such is not the case. The screen is raised at the top left and bottom right as if it is being squeezed with force on the top right and lower left. But it fits flush and there is no pressure on those two sides causing this problem. How should I resolve this issue? Replace the adhesive once more? Any suggestion are most definitely welcome.
Is this a good question?