Issues with Reassembly; Lid Not Closing Easily
A friend had me take her MacBook Pro apart to clean the left fan (following the directions here on the site) and everything went well. However, when I took the top enclosure off, the thin metal brakets lining the underside of it bent and seperated in a couple of places. Most notably was where the lid "latches." After I put the screws back in I noticed that the lid wasn't closing easily (sometimes it wouldn't close at all unless you held it down for a moment) and it concerned me. She took it home and called me this morning (48 hours later) and said she is still having issues with the lid closing. I have tried every search I can think of and haven't been able to locate anything that addresses our issues. I can post photos if it would help, but I'm just at a loss. Any and all help, ideas, and/or comments would be GREATLY appreciated! Thanks in advance!
Is this a good question?