Fix Your Stuff Community Store

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Questions View all

Options

After a screen replacement, the iPhone turns on, but the screen doesnt

Hello everybody,

I have replaced the flex connector and the screen of my iPhone 6 at the same time. After fulkly reassemble it, I tried to turn it on and it worked great. I proceeded to charge the battery with the iPhone switched off and the screen never worked again. I have tried to replace the old screen but nothing worked. I know that the iPhone is on because it vibrates when I change the vibration switch position and also I connected it to a TV with the lightning to hdmi cable.

Thanks in advance

Answered! View the answer I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Chosen Solution

Options

Turn the phone off, then turn it on again.

Shine a flash light on the screen and see if you can see an apple logo. If you do, you have a no backlight issue. That can only be repaired via micro-soldering (replacing backlight circuit components) on the logic board.

Some mobile phone repair shops offer this service.

In rare cases it could be a defective display but no backlight is usually a board issue.

Was this answer helpful?

Yes No
Score 2

1 Comment:

Sorry for the late answer. You are right, with the flash light on the screen I can see it. I will look for a repair shop in spain offering that service. Thanks a lot!

by

Add a comment

Add your answer

Manuel will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 34