My whirlpool front loading washing machine is flashing 1h and has been doing that all night. How do I get that off so I can wash my clothes?
Is this a good question?
Rep: 3.3k
9
11
5
Possible Solutions
There is no error - the Delay Wash is activated
When the display shows a number up to 12, followed by an "h", it means that the Delay Wash has been activated. Most front load washers can be set to delay the wash for up to 8 or 12 hours (depending on your model).
To set the Delay Wash, turn on the power, then tap the "+" or "-" button near the display. See picture below for an example - location may vary depending on model.
Tap the +/- button to increase/decrease the time for the delay in 1 hour increments. Some models have up to an 8 hour delay, others up to 12 hours. Once set to the preferred delay time, press the start button. The display time will decrease every hour until it reaches "0h", and the washer will start at that time. The Delay Wash light will remain on until the washer starts.
To turn off the Delay Wash once it has been set, turn the power button off.
Was this answer helpful?
Past 24 Hours: 1
Past 7 Days: 4
Past 30 Days: 27
All Time: 6,886
2 Comments
This might sound silly, but have you tried unplugging it and plugging it back in?
by Charlie B
Can you post your model number please?
by alex lee