Touch IC iPhone 6 PLus - C2414
Hi EveryBody.
I have a question plz only for general knowledge because I m learning about smd board repairing.
I have an iPhone 6 plus.
If I check the voltage on c2414 it will be 5 volt right?
My question is : the voltage wil be same with or without lcd connector attached? (obviously iPhone must be turn on :) )
I m asking because I have an iPhone 6 plus with no touch responding.
I check the voltage on c2414 and it was ZERO.
I reball u2402 and touch screen begin to function perfectly, but the voltage on c2414 is zero.
So I m confuse, I m not understanding which is the way for understand where is the fault, before recall or changing ic’s.
Thanks a lot for attention and forgive for bad English :)
Is this a good question?
4 Comments
c2414 is on the 5v rail. what does c2409 read
by daniel
Thanks Daniel.. I did not check c2409... Cuold u plz explain what does rail meaning?? c2414 always have 5 volt or not? thanks
by Umer Muhammad
the best person for this question would be @refectio who is the guru of iPhones on here followed by a lot of really smart people like @theimedic and @djdannyrock . I am certain somebody is going to pick this up ;-)
by oldturkey03
can i see C2409 voltage track
by innocentlove4u01