After dropping my phone without anything screwed in, the battery fell out and along with it, the battery connector was ripped off. No solder pad seems to have been affected. How would I go about fixing this? I'm not too skilled in soldering nor do I have the equipment to do so.
Is this a good question?
Rep: 781.6k
1.1k
893
2.3k
@invoxiplaygames the connector will have to be re-soldered (no, you cannot glue this coonector;-). Replacement connectors are widely available on line and since the solder pads still look good, anyone that does small electronic repair could solder this for you. It is most likely that board repair professionals charge by hourly rate and this could cost more than the replacement of the phone. Whom to choose or recommend would depend on your location.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 75
