Released on September 19, 2014, this 4.7" screen iPhone is the smaller version of the iPhone 6 Plus.

3151 Questions View all

clean mainboard connection?

What braid to desolder to clean the pcb iphone motherboard

 

What type of flux to clean pcb connection without damage

Flux no clean or Rosin

Or find a braid of very good quality

clean with iron soldering or hot air

if iron soldering what temperature

if hot air what temperature (my station is three picture)

I am glad that there is very great profesionel on this forum

Thanks to them all

Block Image

Block Image

Block Image

Block Image

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Chosen Solution

I use Tenma, Size #1 Width .035" (0.9mm) Part# 21-8355 but any good quality thin braid of same size with flux would work. Thicker braids tend to be a little harsh and just move the solder instead of soaking up like the really fine braid.

An alternative I have used is to cut a 1 inch piece of braid and hold it in your tweezers. cover all other areas with Kapton tape except area you are working on to 1. protect other components from heat and 2. to keep the other components from moving. put flux down on pads working on and focus heat on braid. then using wick like a paint brush, lightly brush solder (Do not brush against other components) and it will soak up. I keep a few cut pieces near by to change up after piece is full of solder on tip.

Just try to keep it short as an iron is better to focus heat on area you are working on and the hot air is indiscriminate and too much heat is not good for the board or for the components surrounding the area you are working on or the reverse side.

Check out this video at 35 min to about 37 min.

https://youtu.be/_f2SSXYIF9E

Was this answer helpful?

Score 0

Comments:

Thank you for everything michael you is very nice

Would you have the link to buy the tenma 21-8355

by

I purchased locally at radio shack...amazon is out of stock https://www.amazon.com/TENMA-21-8355-ROS... , but any of similar size brand should work

by

Thank you for all my friend you is the best

for zoom i work with :

https://fr.aliexpress.com/store/product/...

What do you think

by

I'm honestly not sure, I have never used one but looks nice :) I use: https://www.amazon.com/AmScope-SM-3TYY-5...

by

Show 3 more comments

Add a comment

Add your answer

Mike Plouvin will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 1

All Time: 66