40in LCD TV released in early 2007

25 Questions View all

I have to reset tv each time I turn it on to get any channels

my tv comes up with a no signal message when i turn it on, i have to to do a total reset to get it to work, all is then fine until i turn it off, then have to to do it all over again next time i turn it on

Answered! View the answer I have this problem too

Is this a good question?

Score 0


@paulineholt how do you perform the total reset? How long has this been going on and has the TV ever fully functioned? Has anything happened that may have caused this?


Add a comment

1 Answer

Chosen Solution

@paulineholt, Pauline, If you have setup your TV as per your TV's manual, perhaps some how the TV is set to Demo/shop/store mode, if in this mode will not retain your set up. See links below for instruction on removing demo/store mode. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.



Was this answer helpful?

Score 2
Add a comment

Add your answer

pauline Holt will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 71