Rep: 11
1
Had to replace the drum bearing, put them in, put the washer all back together, plugged back in, F-73 is the error code. hit the power button 3 beeps goes blank. replaced the ui boards still same 3 beeps and goes dark....HELP
Is this a good question?
Rep: 685.3k
3.4k
1.1k
2.6k
Check the door locking mechanism. Three beeps will give that error.
UPDATE 1/14/17
f 71 user interface heartbeat failure:
if a central control unit heartbeat failure is displayed, no communication is detected from the user interface to the central control unit.
1.) possible causes/procedures:
a. check for continuity of the wiring user interface harness.
b. check wire harness connections to the unser interface and the central control unit.
c. replace the interface if the drum is rotating.
d. replace central control unit if drum is not rotating.
Was this answer helpful?
does this mechanism make a complete cir.. before it will come on?
If the door will not lock, I don't think anything will work. Here's a link to the part:
the door does lock and before when i plugged up the washer, all it would do is flash a code F73, no lights, when u hit the power button or the start button 3 beeps code goes out. when u press the power button 3 beeps that is all. have to unplug and re-plug to get the code back...i am con-fuzzed,,,,help
see update to question
all wires check good
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 102
