Skip to main content

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Questions View all

My screen seems to be forced in my iPhone

I recently purchased the screen replacement full assembly for my iPhone 6, I followed all procedures but it seems like the screen does not fit completely into the phone, its edges are up and the camera does not function except for the video. The screen seems to be forced, when I barley add any pressure the side acts as if im adding too much pressure.

Answered! View the answer I have this problem too

Is this a good question?

Score 1
2 Comments

The thing is that I ordered the piece from Ifixit, the screen seems yellowish and does not seem to fit, the old screen does.

by

Then send it back.

by

Add a comment

2 Answers

Chosen Solution

You could have a low quality replacement screen or your housing is dented. See the attached image for an example.

Block Image

It's a minor dent but it pushes the screen frame down by almost 1 mm. If your housing is damaged, which is not uncommon when a screen is broken, then you need to hammer it (very gently) back into place. I like to use a metal spudger like this . You can use the round end for the corners and the flat end for the straight edges.

Be gentle as the aluminum housing can break very easily.

Was this answer helpful?

Score 5
Add a comment

You can get a High-quality iPhone 6 LCD screen replacement in Etrade.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Marcelo Marquez will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 67