Why washer goes to "ol"during wash/rinse spin
elite,model 110.28032701, after wash no water in tub,clothes still wet,and code"ol"on display
Is this a good question?
elite,model 110.28032701, after wash no water in tub,clothes still wet,and code"ol"on display
Is this a good question?
See my previous answer on this:
Was this answer helpful?
this answer is for a maytag washer,my question was for a kenmore
It's the same answer. OL is an overload code.
@eddie9115 just checked your washers manual and "oL" still stands for overload. With your washer this could be caused by a bad bearing in the outer tub, a bad control board as well as a bad motor sensor. Check to see if you can ran the diagnostics mode and see what it tells you. Let us know. Kenmore 110 Diagnostics
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 3
All Time: 572