Rep: 1
2
I just finished replacing the back cover. And for some reason the vibrate button wont work. it slides up and down loosely but i could hear the clicking when switching up/down. Planning on opening it up agian. I was wondering if there was a special way to put it in or is it just like the volume button where its just the medal piece and and senses when you push down.
Is this a good question?
Rep: 77.1k
335
104
145
when you open the phone back up have a close look at the inside of the switch-you'll see a little groove that the corresponding "toggle" on the vibrate flex fits into. have a go toggling before putting phone together-can take quite a few frustrating goes.... try putting phone on the side, secure switch with "bluetak" in the down position, flip toggle to down and then secure.
switch has a straight and a curved end which will only fit in space one way.
have fun!
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 1,429
