Rep: 27
2
1
1
Hi, we just replaced the display from an iPhone 6S and found that when typing the cursor sometimes jumps into another place by itself. Everything else works fine including 3D. We tried another display, same issue. The original display works fine though. Any ideas?
Is this a good question?
Rep: 459
8
1
Sounds like you have bought a copy display, which are known for this issue.
Quality is key with this model iPhone.
You will not get this issue with original quality displays.
Possibly try:
With the new display connected.
Disconnect the battery and leave it on charge for 10 - 15 mins.
Was this answer helpful?
Rep: 217
3
I was recently speaking to a repairer who purchased a batch of screens (he was told they were original, but they were WAY too cheap to be full original)... and every single one of them had the same issue where one side of the screen was completely unresponsive to touch.
Was this answer helpful?
Rep: 751
6
2
Ghost touching on the the screen is very common with cheaper screens, the first 6s i repaired had this issue but now we have switched over to a better quality of screens and have had no problems
Was this answer helpful?
Seems like the iPhone 6S replacement screens appear to have quality issues overall. I'm avoiding purchasing any replacement screen until the failure rate decreases. Correct me if I'm wrong.
Synced repair NZ, may i ask where do you buy your orginal screen( OEM)?
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 135
Where did you get the screens from? Could be bad quality screens but I could be wrong.
by Ben