Rep: 45
2
1
Hi,I have a damaged J6 battery terminal and FL11,C279 and C23 are missing.I have a new J6 but wondered how to solder the other componenst onto the board and after that which are the soldering points on J6.All of them or only certain ones.I have a photo of the problem but not sure how to add it to question. Also in the picture you can see scratches with the copper showing through,does this matter?
Is this a good question?
Rep: 782k
1.1k
893
2.3k
@birdbrain not exactly sure what you are asking. The pads as well as the components are outlined in the schematic
As for how to solder it, you will need a proper rework station, a good microscope and steady hands:-) If you have never soldered small stuff like this, your 5S may not be a good place to practice. you should consider having someone else do it for you. Yes those scratches can cause problems if they get shorted out. I usually try and cover those with non-conductive glue/paint.
Was this answer helpful?
Thank you for your reply.On the schematic is each blue mark a soldering point for the component?
@birdbrain yes it is
Thank you so much,its good to clarify that.
Past 24 Hours: 1
Past 7 Days: 1
Past 30 Days: 1
All Time: 565
4 Comments
I have similar problem with iPhone 5C some of the capacitors are missing C23 and C25.
by Mimi
@birdbrain use this guide Adding images to an existing question to add images.
by oldturkey03
Thank you for that.
by john byrne
If you go to @jessabethany you will find her email address there and she is likely the best person here to answer your question. Micro soldering is definitely her thing
by Jimfixer