Rep: 81
3
2
The screen bit is comming away from the frame, any ideas if this can be fixed or the whole screen needs to be replaced? Or can i put glue there? what kind of glue would I need? Any help would be much appreciated!
Is this a good question?
Rep: 57.5k
18
77
212
It's most likely the parts you used, to replace your screen. Sometimes I see it happen with oem screens. I also usually use a flathead screwdriver, and carefully pry the bottom of the assembly up. You can try some super glue or something. It might work. Or you could buy a quality part from ifixit. That would solve your problem also
Was this answer helpful?
Rep: 2.3k
6
4
2
yes, that can be glued, use your imagination on what glue to use. That suction cup instead of an isesamo might have something to do with it lifting that way. Otherwise its a parts quality issue and you should be aware as you order additional parts, if all the parts from a particular supplier lift that way, its time to find a new supplier.
Was this answer helpful?
would superglue work?
I mean it might. You also gotta think. Superglue usually leaves kind of a non clear grey residue. Especially if you put too much
what about loca glue?
Usually clear. Really should use a uv light though. To get that to harden
awesome will give it a go tomorrow
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 134
