Rep: 11
1
I replaced the screen on my gold 6 plus, I decided to put a black screen on Iit and everything went well until I turned the phone on and the screen was unresponsive to touch. Before complete installation I did test the screen and it worked . The screen has light lines running down the screen please help
Is this a good question?
Rep: 102.5k
18
191
304
I would take the phone apart again and get it to were it worked before then re assemble slowly and with care checking when possible if it works to know when things go wrong.
Was this answer helpful?
Rep: 2.2k
4
4
1
Sounds like the digitizer flex cable or socket on the board may be damaged. I would inspect those areas under a microscope.
Was this answer helpful?
Could also be a short , did you put all the insulating tape back on?
When I extend the flex cable while it's plugged in the screen becomes clearer, but still lines going through
Rep: 1
5
4
Your digitizer flex isnt properly plugged in most likely.
Was this answer helpful?
When I extend the flex cable while it's plugged in the screen becomes clearer, but still lines going through
Rep: 109
3
2
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 328
2 Comments
Does the home button work?
by Jimfixer
I didn't attach the home button backing plate yet because I have a stripped screw and ordered a new plate, but the touch id was still funtioning
by Josh B