no sound out of speakers after ipad 4 digitizer install
I've been looking all over the internet for a fix and I found nothing.
I've installed a new digitizer from here (ifixit) and everything installed great. The issue is that now I can only get sound from the headphones.
I've tried:
holding the home and power button for 10 seconds to do a reset
[didn't work]
Going into the general setting and changing the accessibility for mono sound
[didn't work]
checked the sound switch on the side and changed settings in the general settings
[didn't work]
gently cleaned out the dock connector and headphone jack of any debris
[didn't work]
More info:
The ipad is running IOS 8.3
There is no "headphone" notice when I try and change the volume. it just says volume.
Is this a good question?
Is it possible that the speakers came u plugged when you were changing the digitizer? Did you remove the logic board for any reason during the repair?
by Brian
I didn't touch the logic board at all. Not sure what the speaker connector looks like. Just followed the ifixit guide
by Abstruse Thoughts