I was replacing a screen on an iPod touch and had to replace the bezel. After I replaced the bezel and put the new screen on everything worked except the touch screen. I even put the old screen back on to see if it was a bad screen but that didn't work either. I think it may be the adapter but i'm not exactly sure. I have tried to reset it but nothing it working. Thanks.
Is this a good question?
Rep: 3.6k
8
6
2
Make sure you are connecting the digitizer correctly. If You are then look for damaged connector. I've seen a few where connector on logic board is damaged due to incorrect placement attempts
Was this answer helpful?
If this was the problem which it most likely is, would there be a way to fix the connector on the logic board?
Yes they are replaceable. This is the part you would need to buy http://www.ebay.com/itm/2X-Connector-iPo... This part replacement requires micro soldering. If you need further assistance let me know.
Thank you or your help I actually put the screen into the bezel and it started working fine. Thanks again
Nice! glad it worked, placing those can be tough sometimes :)
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 1
All Time: 83
