Rep: 13
1
Navibot sr8855 after repair of FET tranzistors for brush have bad mooving - navigation.
From the beginning it worked well and after some time was problem in navigation.
It looks like that: move 20-30cm stop and go back about 3cm, turn 90st. and repeat.
Sometimes work good for 1 minute and then again fail to this state.
I try test mod and all sensors look fine, motors are OK too.
Is this a good question?
Rep: 13
1
Hi,
yes, i found that it was dusturbation in system . I add some capacitors on motor and all is OK
Was this answer helpful?
Can you describe more precise what did you done?
Could be the aging of the accumulator?
Was this answer helpful?
Rep: 13
1
I must replace suction motor and with it start the disturbance of electronics. For this I used capacitors on motor pads. I was 1nF + 100nF + 1uF together. To other motors must be carefull becouse are PWM drivered. There You can use only some smaller - max 100nF capacitors.
Was this answer helpful?
Hi
What voltage do you use in capacitors?
Rep: 13
1
It could probably have an effect but it is not a reason.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 1
Past 30 Days: 4
All Time: 1,930
I have the same issue. Is there a fix?
by mirceaghita