Replaced digitizer, but touch stopped working after a while.

Question

iPhone 6 Plus

Repair information and guides for the iPhone 6 Plus that was released on September 19, 2014. Model: A1522, A1524

1525 Questions View all

ca2pedersen @ca2pedersen

Rep: 13

1

Posted: Jun 21, 2015

Options

Replaced digitizer, but touch stopped working after a while.

Replaced a broken digitizer on my iPhone 6 plus, following this guide iPhone 6 Plus LCD and Digitizer Replacement Used the phone with no problems a whole day, then the touch stopped working.

I've reconnected all the connector cables, worked almost a whole new day, then stopped working again. If i turn the device off, and on again the touch works for like 5 minutes before it stops working again.

Any Ideas on how this problem can be resolved?

Answered! View the answer I have this problem too

Is this a good question?

Yes No

Score 1

1 Comment

Did you find any solutions or answers?

I've been repairing phones for 22 years and I have seen this on an iPhone 6 and 6+ now. I only replace with real OEM screens assemblies, and the the screens are tested on other iPhones and they still work fine. But on these two the digitizers, much like the OP, stop working after a minute or two. There is something going on, maybe a digitizer module?

Sep 15, 2015 by Peakcelln

Add a comment

2 Answers

Chosen Solution

PhoneOpsPlus @phoneopsplus

Rep: 21.2k

PhoneOpsPlus

5

19

70

Posted: Jun 23, 2015

Options

Sounds like you may have bought a faulty LCD, I would get it exchanged, that should solve it.

Was this answer helpful?

Yes No

Score 1

Add a comment

Did you find any solutions or answers?

I've been repairing phones for 22 years and I have seen this on an iPhone 6 and 6+ now. I only replace with real OEM screens assemblies, and the the screens are tested on other iPhones and they still work fine. But on these two the digitizers, much like the OP, stop working after a minute or two. There is something going on, maybe a digitizer module? — Peakcelln