All-in-one printer and scanner.

9 Questions View all

Instructions for dismantling the printer.

Need help or instruction for dismantling the printer. He fell into a small object, and does not feed paper.Stef

Answer this question I have this problem too

Is this a good question?

Score 5
Add a comment

2 Answers

Most Helpful Answer

https://www.youtube.com/watch?v=yGnRWUL7...

Was this answer helpful?

Score 2

Comments:

Thanks for the link this is very helpful!☺

by

Add a comment

Follow The Steps to Dismantling the printer

Step 1: Lift up the Deskjet's top plastic cover and wait for the ink cartridge carriage to slide out from the left side. Pull up the two ink cartridge covers and remove the ink cartridges.

Step 2: Leave the top cover open and unplug the Desk-jet's power cable. Disconnect the USB cable. Locate the four locking screws on the top-left and top-right sides of the Desk-jet.

Step 3: Remove the screws with a hex screwdriver and pull the top half of the case off the Desk-jet printer. Remove the screw on the left side of the button control panel and pull the panel off the printer.

Step 4: Locate the thin, green plastic ink absorbed at the bottom of the printer's case. Pull the absorbed toward you and lift it out of the Desk-jet.

Step 5: Remove the screw holding the printed circuit board in place at the right end of the Desk-jet. Pull the circuit board out of the printer.

Step 6: Remove the screws at the left and right ends of the ink carriage and pull the carriage out of the printer. Turn the printer around so the back end is facing you.

Step 7: Push in the visible plastic latches and pull apart the top and bottom halves of the plastic casing and finish disassembling the HP Desk-jet printer.

Was this answer helpful?

Score 0
Add a comment

Add your answer

stefan will be eternally grateful.
View Statistics:

Past 24 Hours: 2

Past 7 Days: 11

Past 30 Days: 47

All Time: 1,150