No longer boots properly after plugging in wrong voltage?
I have a Ubiquiti Unifi AP UAP-US. Plugged wrong voltage 48 volts into 24 volt power unifi ap.
AP still lights up but keeps blinking orange.
Is there a voltage regulator or chip that I can replace to get this working again?
If so where can I order the part?
thank you.
Is this a good question?
Score
0
Most likely, but there is no way to answer "voltage regulator or chip that I can replace to get this working again?" this. you will have take a look at the circuit board to make any determination of what might need to be replaced.
by oldturkey03