I have been using this espresso machine for about a month. But this morning when I pressed the switch to turn it on nothing happened. So I took off the bottom and all of the wires looked fine I wriggled the connection and the light for the switched blinked. But no luck getting it to work again.
What next?
Is this a good question?
Rep: 842
10
1
2
Most likely the pump in the machine has stopped working. In order to test this you need to remove the white and blue wires from the back of the on/off switch. Next acquire a multimeter and place it on the resistance setting, then touch the multimeters leads to each wire. If functioning properly there should be 0 (or close to 0) ohms of resistance, if you do get a reading besides 0 the pump most likely needs to be replaced. You can also test the switch with this method.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 365
