Skip to main content

A compilation of guides for counter-top and handheld blender repair.

343 Questions View all

Trying to disconnect the drive gear from a bullet blender?

I tried to uninstall the drive gear on the bullet blender. The screw in the base won't hold a screwdriver and the gear is too tight to get it off as the driver slips in the slot. Would like to know if anyone has a better technique to take it off for replacement.

Answered! View the answer I have this problem too

Is this a good question?

Score -1
Add a comment

1 Answer

Chosen Solution

Nick Steffen, I hear you. That was a bear to take it. You can disassemble the blender leaving the gear on. Then place the stator in a vise at the end where the slot for the screwdriver is. Use a pair of good channel lock or vise grips to take the gear of. It is easily possible that you will destroy the gear. Make sure you have replacements.

Was this answer helpful?

Score 1
Add a comment

Add your answer

Nick Steffen will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 63