Rep: 384
9
1
1
After I'm done using my JD Razor 2000 scooter, I always try to fold it and stow it away in my garage. However, no matter how hard I try, I just can't get the darn thing to fold! Any suggestions?
Is this a good question?
Rep: 299
8
5
First, make sure you turn the Joint release latch located right behind the front wheel of the scooter.
As you turn the latch, fold your scooter and it should fold easily.
If it doesn't fold, be sure that the scooter's handlebars aren't blocking the scooter from folding fully and the alignment wheels at the bottom of the handlebars are in-line with the folding mechanism.
If your scooter is still not folding, it may be due to debris stuck at the quick release latch. To find out how to disassemble your scooter and remove the debris, visit the Quick Release Lever Replacement Guide on the JD Razor 2000 Device Page.
Visit the JD Razor 2000 Troubleshooting Page to find any more problems with the folding mechanism.
Was this answer helpful?
Rep: 731
5
Hopefully this helps!
Was this answer helpful?
Past 24 Hours: 1
Past 7 Days: 5
Past 30 Days: 44
All Time: 4,815
