Fix Your Stuff Community Store

Repair information and guides for the fifth generation of iPhone. Model: A1387

2191 Questions View all

Options

Reboots after replacing power and sensor cable

I just replaced the power and sensor cable to fix an inop power button. Now when I plug it into the computer it starts to boot, then reboots, and shows some script it is running, but never gets past the apple logo screen with some script. Randomly reboots. Any ideas?

Answer this question I have this problem too

Is this a good question?

Yes No
Score 1
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Most Helpful Answer

Options

Try powering it on with the replacement parts detached. If it boots normally, then acquire new replacement flex cables. If not- check for damage to the mother board.

Was this answer helpful?

Yes No
Score 1

1 Comment:

This was great advice. Just remove the Headphone jack/volume button cable and then the Power button cable (located underneath the headphone jack/volume button cable) plug it in with USB and it will boot normally if it is a problem with the Power and Sensor Cable .

by

Add a comment

Add your answer

cjbaker790 will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 84