I recently replaced my ipad mini digitizer, and everything went fine. The problem now is that the home button works fine, but the touch screen doesn't work at all. I purchased this digitizer from Iparts outlet on amazon.
Is this a good question?
Rep: 37.6k
22
51
42
Sounds like a faulty digatizer or you have damaged or creased the cables try working the touch when it's at 90 degree angle
Was this answer helpful?
I tried to use it at a 90 degree angle. Didn't work. Yea, possibly a faulty digitizer..
Rep: 917
9
20
2
Hi,
i own a repair shop, and is hard to give warranty for this type of repair. Since some clients will come back after 60+ days. With the crazy digitizer issue, even if i i can triple check that before finishing the repair i wont get the issue.
I transfer the tape and in some cases I put some new ESD tape on the bottom part.
Not every repair will end up with issue. But some of the digitizers will act randomly.
I only buy this replacement parts with the IC chip pre-soldiered.
I can only guess that the IC Chip or the digitizer itself are bad.
Was this answer helpful?
Rep: 37.6k
22
51
42
Hello again I guess it all boils down to the quality of the part .
my suppliers screens use the original home button ic from an original iPad mini screen and have never had an issue with the iPad mini but it is a bloody pain to repair and in my eyes the most difficult Idevice to repair bar the iPod 5th gen
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 1
Past 30 Days: 1
All Time: 1,173
Any ideas to try? Before I send the product back? (Digitizer)
by Kenny