Rep: 1
1
Uniden Model: TCX800 handset - a capsule shaped piece (12.2M-4KU) broke off the circuit board. It looks as though it was glued on. If so, what type of glue do I use? It is obvious that I am not a student, just a mom with a broken phone.
I did not see where I could edit on my original post so I've added the images here:
Is this a good question?
Rep: 782k
1.1k
893
2.3k
Kelly Creech, that component looks like a Crystal/ Oscillator which would correspond with the "X" as reference designator. Most likely a 12.2mHz and I am sure we could locate that if needed. Right now, you can strictly solder it back. All you need is a small soldering iron some flux and solder and a bit of practice. For some decent tutorials, check here and hereas well. Hope this helps, good luck.
Was this answer helpful?
Rep: 30.6k
25
71
41
Hi Kelly,
You can totally solder that back on mama! Just make sure you don't "just try and superglue it and see what happens" --that won't work and it will mess things up for when you have to do your solder work.
jessa
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 920
Kelly Creech, any chance you could post a couple of images of the component as well as the logic board so we can see what you see/ Parts like this are usually not glued but surface soldered. To add images to your question, follow this guide Adding images to an existing question
by oldturkey03