Rep: 53
1
5
The problem started with a shreded belt. That was replaced. Then the check printhead path error showed up. The rods have been oiled, the carriage height has been adjusted. When it powers up it runs through some self tests then the carriage moves a fraction of an inch and the error pops up.
Is this a good question?
Rep: 25
2
Either the belt pulley is broken, or installed incorrectly, or the belt was installed backwards.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 229
