The Kenmore Elite HE3 is 7.2 cu. ft. capacity electric dryer by Kenmore.

198 Questions View all

Kenmore Elite h3 dryer won't start

When I make a dryer selection and punch start (or hold start for 2-3 seconds) it will not start. It beeps 3 times, and the time light begins to flash - but it doesn't start the dryer cycle. appreciate any suggestions!

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment
New Battery = Faster iPhone
Fix Kits starting at $16.99

1 Answer

most likely you have either a bad door switch or an open thermal fuse. the thermal fuse is located behind the toe kick panel. remove the toe kick by removing 3 screws (t20) at the bottom of toe kick. then open the door and remove the lint filter. behind the toe kick is a fan duct that needs to be removed should be 3 1/4"screws. behind the fan duct is a white plastic fuse that has 2 blue wires connected to it. remove one wire and test for continuity. if the fuse is open replace it. then reassemble in reverse order

Was this answer helpful?

Score 0
Add a comment

Add your answer

Fidele will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 28

All Time: 5,934