Skip to main content

Device repair and troubleshooting manuals for fixing accessories made for Nintendo's numerous video game consoles.

23 Questions View all

Screw driver to disassemble the wii nunchuk

Does anybody know if the driver for the diy 54 bit driver kit will fit to remove the tr-wing screw on the wii nunchuk?

If not is there a recommended driver I can purchase from ifixit?


Answered! View the answer I have this problem too

Is this a good question?

Score 1
Add a comment

1 Answer

Chosen Solution


The tri-wing screws used in the Nintendo Wii are Y0. This bit is in the 54 bit driver kit, but you can buy this screwdriver alone too.

Here are the links:

54 Bit Driver kit:

Y0 screwdriver: Tri-point Y0 Screwdriver

Tri-point Y0 Screwdriver Image


Tri-point Y0 Screwdriver


Was this answer helpful?

Score 2


excellent. I did end up getting the 54 bit driver kit however i was worried that on the wii nunchuk it would be too narrow for the driver from the kit to fit. Can anyone confirm this? Thanks!


In case anyone else is looking for this answer. The Y0 in the 54 bit driver kit is too wide. The tri-point Y0 standalone screwdriver however worked perfectly.



There a guide here (Nintendo Wii Remote & Wii Nunchuk Accessory Disassembly/Reassembly) which says "Tri-point #1". Is this a mistake?


Add a comment

Add your answer

Jase1516 will be eternally grateful.
View Statistics:

Past 24 Hours: 4

Past 7 Days: 10

Past 30 Days: 35

All Time: 5,577