hello i open my imac 21.5 intel core 2 duo 3.06 ghz and broke my connect on my display that on the board idk what part do i need to replace to get my displace working again help plz
Is this a good question?
Rep: 781.6k
1.1k
893
2.3k
Levy Hernandez , the connector on your board is a I-Pex20455-030E and those are readily available for a few $. Problem is that depending on what the damage is on your board, it will be very difficult to solder. You may consider getting somebody with the right tools and the experience to solder that back on.
Was this answer helpful?
Rep: 116.3k
66
68
359
Soldering logic board components is not a DIY project. It requires special tools (fine irons) special solder and lots & lots of practice. An electronics repair shop may be able to do this for you. You'd need a new-or replacement board connector/ribbon cable... without pictures I can't tell what you broke.
If this Answer is helpful please remember to return and mark it Accepted.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 118
