Rep: 285
6
11
Hello,
I replaced the sensor/power cable.
Power button works perfect but no sensor.
I tested with other cables, but no succes unfortunately.
Who can help me?
What can i do?
Is this a good question?
Rep: 103
2
1
in my experience if u put a small piece of scotch tape covered in sharpie over the sensors before installing the new screen works for me. its not an issue with cables or anything its because its a different tint of paint on the two little holes.
Was this answer helpful?
Rep: 5.5k
20
17
12
you may have a logic board failure. Check the connector. If it is damaged, you need to replace the logic board unless you are talented in micro soldering.
Was this answer helpful?
There is no problem with the logic board.
Before the replacement worked perfect and now the sensor doest't work.
I have experience with the iPhone 4 sensor problem. On the iPhone 4 is a sensor sticker the sullution.
Maybe on the 4s to?
Rep: 5.5k
20
17
12
If multiple cables do not work, it must be a logic board issue.
Was this answer helpful?
Good news.
I just put my logic board in another iPhone 4s and the sensor works then.
There must be wrong with the cable dan.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 157
