replaced hard drive,black screen,wrong install disc,
hard drive works,put in wrong disc and will not eject.Screen is black and beeps about every 3 seconds.
Is this a good question?
hard drive works,put in wrong disc and will not eject.Screen is black and beeps about every 3 seconds.
Is this a good question?
You don't have your RAM in right either... that's the beeping and failure to start. Go over reassembly again. Holding down the space bar or mouse at startup should eject the disk unless it's jammed or a micro disk.
If this Answer is helpful please remember to return and mark it Accepted.
Was this answer helpful?
After reseating your RAM, hold down the mouse button on restart to eject the disk.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 175