Repair guides and support for the 5th generation Honda Civic, first released in late 1991.

44 Questions View all

Fan not working with new therm switch.

Fan will run with paperclip jump but will not run on new sensor, car over heats, fan does not kick in whats the deal ?

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Chosen Solution

David, since you know your fan works when you bridge the connection and already replaced the sensor, check the green wire of the Cooling Fan Motor Switch connector. If there is no power there you have either a bad Cooling Fan Motor Switch Relay, an open between the Cooling Fan Motor Switch, or a blown fuse. the attached diagram should help you to trace the connections. My money at this point is on the relay. Hope this helps, good luck.

Block Image

Was this answer helpful?

Score 1
Add a comment

Add your answer

David will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 12

All Time: 427