Fix Your Stuff Community Store

The third generation of the Toyota Camry in all markets outside Japan. 1991-1996 was also called the XV10 series of Camry vehicles.

79 Questions View all

Options

Why won't my sterio work?but did before?

i put a cd player in my car before and switched it out for a newer cd player.now that i put a new one in it won't work.i double checked to make sure all wires where right and fuses...What else could it be for it not to work?

Answered! View the answer I have this problem too

Is this a good question?

Yes No
Score 1
2 Comments

Is it an aftermarket stereo or a Toyota brand? Do you use an amp with it? What was the issue with the old one? You just replaced it to go with a newer player?

by

i just replaced the stereo for a newer one. there is no amp connected.ok i will check the wires again..thank u both very much

by

Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Chosen Solution

Options

First thing I would do is test the power wire to the stereo with a volt meter and see if you are getting 12 volts from it and at the same time make sure the Ground source is also working, if that is good I would look for a fuse that is in the stereo itself and see if it's good, if that's all good then I would have to think the stereo may be bad.

Was this answer helpful?

Yes No
Score 0
Add a comment

Add your answer

gamesnotwar will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 334