Rep: 13
1
1
Mower turns on but will go neither forward nor backward. Just had it serviced at 25 hours last week. The pull knob for pushing the mower is not engaged. It is in position for the mower to be self propelling.
Is this a good question?
Rep: 79
2
check and see if the “axle key” are still in
Was this answer helpful?
check to see if brake peda isl released
There is a vacuum hose going from the front to back on the YV 4000 Craftsman . It rides above one of the pulleys on the deck (left side) and the hose can be cut into by the pulley. You might replace the hose (or tape it up) then use a wire tie (not too tight) or something to hold the hose up.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 1,903
